Week of 9/26/2018

The objectives of the team were changed last week with input from Dan and Dr. Furman. The scope of the team now includes:
  • Designing articulating axles of the bogie.
  • Designing spring loaded guide arm
  • Designing emergency braking system.
  • Providing mounting points for the hub motor axles to motor team.
For the previous week, the team also worked on the redo of the proposal which is linked below. For this week, Presentation 1 was the main focus. Over the past two weeks, the team had been working on their design ideas, researching relevant topics, and performing calculations pertaining to each members parts. Currently, the different scopes are divided among the team member, and detail information of the different duties is provided in the presentation which is linked below. The team also has provided a Gantt Chart for this semester keeping in mind the goal of Maker Faire.



Comments

Post a Comment

Popular posts from this blog

Week 11

Image
Week 11, For this week the team continued to work on our individual components Articulation: currently redesigning thrust bearing carriage, need to consider there being an axle that connects both wheels together. currently designing pins that will lock in place for the steering rack, Guide Arm: currently working on improving on the design for the spring holder and wheel holder the Safety factor is really high attempting to decrease material and make design changes to improve design and optimize for safety of factor above 2, but not extremely high. images of the components are provided that show area where material can be removed. furthermore, the prototype should a concern a different loading concern when it comes off of switching tracks, the force will not all be perpendicular to the track, so additionally FEA was done with different loading conditions. minimum Factor of safety = 27 goal for next week start report Redesign the "arm" for the
Read more

Week 10

Image
Week 10 this week the team worked on finishing up solid work models and conducted FEA on most of them Through rapid prototyping we were ale to see that our designs had a few problems that needed to get fixed before the final product. Articulation The problem with articulation structure where it would fail when loaded with 2500lb was fixed by adding a small section that helped reduced the moment arm caused by the bearing carriage. Shown in next figure.  The following figure shows the redesigned part. This new design greatly reduces the moment arm allowing the structure to carry more weight. This design has a factor of safety of 8.86 this means there is alot we can do to improve the design and reduce its weight from current 14 pounds. Since the bogie will not be using an axle we had to think of a new way to mount wheel housing to the new articulation system for now we designed this component which works as a carriage for the thrust bearing and also has mounting holes
Read more

Week of 05-15-2019

This was the final week of the Spartan Superway project. The team has learned so much over the past several months and the experience is invaluable. The final presentation went smooth and better than we had expected. Overall all of the team's goals were met and we are extremely proud of that. I hope that next years team will continue working hard on the Spartan Superway so we can one day make it a reality.
Read more